Automates the switching on of the Cinebasto
Switch it on or off remotely
- Warm up the motor home before your arrival
- Switch it off if your plans have changed and come back later
Conditions ignition
- Based on too low a temperature
- Depending on battery voltage
- At a particular time
Condition switch-off
- Based on too high a temperature
- If the Battery is discharging
- After a certain time
Remove the front glass
Use a small suction cup
Thanks to a small suction cup, it will be possible to remove the front glass with a slight force.
Open the container
Use a precision screwdriver
Unscrew the 4 small screws that keep the container closed.
Access electronics
Remove the cover and take out the electronics
Once the container is open, it will be possible to access the on/off button on which you will connect in parallel with the CamperCheck
ON/OFF button
We access the button on weld
For ease of illustration, the 4 pins of the on/off button have been numbered .
Pins 1 and 3 are GND
Pins 2 and 4 are the signal that must be temporarily brought to GND to switch the cinebasto on or off.
Let's prepare the CamperCheck
Just a thread to take to the cinebasto
By connecting pin 8 to GND, via the APP button, we can bring the output OUT2 (pin 7) temporarily to GND, simulating pressing the button
Soldering the ignition wire
We run a small cable together with the power supply
By connecting pin 7 of the CamperCheck to pin 4 of the on/off button on the kinebasto we will have completed the installation
The end result
An overview of the connection
In this way, the cinebasto can be switched on and off, either from its own button or from the CamperCheck
Manage from the APP
automate as you wish
Switch the cinebasto on and off automatically or manually, remotely, or from the motorhome... you decide according to your needs
Switching on from the APP
Short pressure
To switch on the cinebasto, the button must be pressed briefly.
This has to be simulated by CamperCheck.
To do this, it would be possible to press the CH2 button and after a short time press it again to simulate finger release.
One solution to make the CamperCheck do this automatically is to set an automatic button release after 0.5 seconds.
Switching off from the APP
Long pressure
To switch off the cinebasto, the button must be pressed. for a longer period.
This has to be simulated by CamperCheck.
To do this, it would be possible to press the CH2 button and after a suitable time press it again to simulate finger release.
One solution to make the CamperCheck do this automatically is to set an automatic release of the button after 2 seconds.
Another Cinebasto model
Another model
centre right button
In this case, power is switched on with the cetral button on the right side
seen from behind
new model
a detail of the Cinebasto control board
Detail of connection
example using OUT2
Instead of 2 wires, it is possible to connect only OUT2 as in the previous case, but since the ground is carried a little differently in this case, we preferred to connect 2 wires.
See the video on the YouTube channel
A short demonstration
installation in a motorhome
In this video we show the first installation that was done.