Output control
A dry contact output is available on CamperCheck 1.0
This output can switch any equipment on or off.
ATTENTION
This output cannot withstand loads:
- Maximum voltage 36V DC
- Maximum current 100mA
IF YOU WANT TO DRIVE A LOAD
this output must be used to energise a relay suitably dimensioned according to the load.
Output control
In CamperCheck 3B is NOT available
In the CamperCheck 3B the two available outputs were used to manage the selection of the 3 batteries.
CamperCheck Presentation
To get a more complete idea of how CamperCheck works you can go to the YouTube channel.
In the video on this page you can see how to use the CamperCheck as an On/Off switch with remote control.
Periodically the channel is updated with new videos, you can subscribe to stay updated.
We explain step by step how you can use the output of the CamperCheck to automate the use of the cinebasto.
Driving a relay
The device is switched on by the relay
It is possible to switch on any device indirectly. The output of the CamperCheck energizes the relay, which must be sized appropriately according to the load.
